EPP Handlaunch Glider by Richter R/C - July 10, 2004

Last update: August 2, 2004

L
Online Building Instructions Index

The sections in the index below correspond to each text section in the building instructions included with your kit. Click on each link for text and supplementary pictures.

Note: When instructions state, "refer to plans", see printed schematics included with kit.

For printing, make sure to set your left and right margins to 0.5 inches, or 1 cm (for standard 8-1/2 x 11-inch paper). You can do this by going to the "page setup" menu. If you do not change the margins, some of the text may be cut off during printing.


1. Sanding Dihedral Angle and Installing Carbon Spars

2. Installing Antenna

3. Covering Wings - Packing Tape Method

4. Joining Wing Halves

5. Cutting Hole for Servos

6. Assembling Pod

7. Covering Pod

8. Attaching Pod to Wing

9. Installing Servos

10. Installing Pushrods and Control Horns

11. Setting Approximate Elevon Neutral Position

12. Attaching Coroplast Fin-mount

13. Assembling Fin

14, 15, 16. Setting Control Throws, Balancing, and Flying

All text, images and other content © 2003 Richter R/C. All rights reserved.