back to index 8. Attaching Pod to Wing 33. Using a rag soaked with a bit of alcohol (denatured or rubbing), clean bottom and top of wing in the vicinity where the pod will attach. In addition, clean the covering material around the perimeter of the pod's wing saddle. A hot glue fillet will be applied to this area, and thus the surfaces should be free from grease to ensure a good bond.   34. Feed the antenna wire from wing through the servo access hole in pod. Slide pod onto wing and center it. Put a small dab of hot glue between the rear end of the pod and the wing. Press pod against wing until glue sets.   35. To mount the pod permanently to the wing, a fillet of hot glue will be applied around the perimeter of the pod (see plans). This fillet will bond the pod to the wing. To do this, run a small bead of hot glue around the perimeter of the pod, in the corner between the wing and pod. Move the glue gun slowly while pressing the nozzle into the corner. Try to apply an even stream of hot glue to the corner. If you miss an area, you can always come back and re-apply glue. To finish the fillet, run the heated nozzle back and forth along the fillet to shape it. Use the hot-glue sparingly as it is heavy. Allow hot glue to cool and set. 9. Installing Servos All text, images and other content © 2003 Richter R/C. All rights reserved.