back to index 7. Covering Pod It is possible to cover the pod with tape or a low temp iron-on covering such as Econokote or Black Baron Film. The iron on coverings have the advantage of conforming to the compound curves better than the tape, however care must be taken not to over shrink the covering and deform the shape of the pod. 30. Spray pod with two light coats of adhesive and allow to dry approximately 10 minutes. 31. Cover pod either using tape or iron-on covering. If using tape, you will need to cut it into smaller strips to get it to conform to the curves of the pod. Use a squeegee to smooth the tape onto the pod. If using iron-on film, cover the pod with four separate pieces of film, one on each side (you may need an extra piece on the nose. Overlap all pieces by about 5mm. 32. Cut away material covering compartments.     8. Attaching Pod to Wing All text, images and other content © 2003 Richter R/C. All rights reserved.